|Aug 27, 2014, 12:19 PM|
Joined Jul 1999
Tail Build Images (TB-1-1 build method)
Here is a look at some simple tail fixtures that can be used to build the tail.
1/4" press board
old kitchen door
You need 3 small nails and some tape.
Notice when the carbon is on the bottom I use the edge of the board to keep the carbon from sliding up while the glue dries. With carbon on the top I used a ruler to keep it from sliding.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||Equipment for testing ornithopter||BrokenSmile||Ornithopters||9||Oct 16, 2013 01:25 PM|
|George Buckley's ornithopter project.||Plantoflap||Ornithopters||25||Jun 06, 2012 11:29 PM|
|Question||Conversion (Rubber Band to Motor) Ornithopter Project||Jerry Rose||Ornithopters||34||Aug 13, 2004 11:34 PM|
|Yippee!||Ornithopter Project Step One||Jerry Rose||Ornithopters||12||Jul 24, 2004 05:45 PM|
|New Project Gallery at The Ornithopter Zone||Chronister||Ornithopters||12||Feb 08, 2004 03:33 AM|