Thread Tools
Old Sep 02, 2012, 07:34 PM
jim2wright is offline
Find More Posts by jim2wright
Registered User
Joined Mar 2012
82 Posts
cutting props down for pusher slot jets

Built a 26 inch ws slot pusher. Flew it with a 7x3.5 GWS. Flew ok but a bit slow. Took a master airscrew 8x4 and cut it down to a 7X4. Plane flew noticibly better but the motor was hot (not warm) afterwards and I only did 2 short full throttle runs. Should I cut it down another 1/2 inch to help the motor survive? Will that make enough of a difference in engine logevity?
thanks in advance.
jim2wright is offline Find More Posts by jim2wright
Reply With Quote
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Pusher Prop Jet F-22 100mph quest Ron_RC Pusher Prop Jet Models 18 Jun 16, 2015 02:20 PM
Discussion Slot jet pusher, shortening props jim2wright Electric Plane Talk 3 Sep 02, 2012 10:26 PM
Discussion Slot-jet >> ducted prop conversion georgy Foamies (Scratchbuilt) 3 Aug 22, 2012 03:32 PM
Discussion Skyangel / HK Nano jets Mig -29 converted to Pusher Prop UNGN Pusher Prop Jet Models 11 Jul 16, 2012 08:54 PM
Question 1st Prop-in-Slot Jet georgy Pusher Prop Jet Models 13 Mar 13, 2012 08:38 PM