|Feb 21, 2013, 04:34 PM|
Sorry for not searching but this site is slow on my phone...
Story, my boss has a Zagi glider ( no motor) and we tried it out the other day and it needed full up elevator to keep it from diving straight down. I know only a little about planes and less about ones without a tail and even less about gliders. So a quick question, where is the CGsupposed to be? I think he said the book put it at 7" from the tip.
Let me go find the box so I can give the model or size, whatever.
|Feb 21, 2013, 07:53 PM|
Enter the measurements of the Zagi in here: http://fwcg.3dzone.dk/
Since it's a glider, I'd suggest using the 20% value instead of the 15% since gliders prefer to be a bit tail heavy.
BTW, that link is posted in a stickied thread on the "Flying Wings" forum in the electric airplanes section.
|Feb 26, 2013, 11:57 PM|
Way too nose heavy. Try moving the CG back to 7.75"- 8" back from the nose, and reduce the control throws.
Also, when you get it flying, you'll need about half the elevator throws -vs- aileron throws.
Learn to throw it with your four fingers under the nose, and your thumb on top. You can actually get a pretty decent throw this way.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Careful!||Zagi 33Hp small hints||benjamin presten||Flying Wings||0||Jan 05, 2013 10:16 PM|
|Discussion||Zagi 120 cm.||firpofra||Aerial Photography||3||Jan 05, 2013 08:04 AM|
|Sold||Zagi 3C Kit||DlgHucker||Aircraft - Sailplanes (FS/W)||0||Jan 03, 2013 04:37 PM|
|How do I move my Zagi cg back?||emaij||Foamies (Kits)||3||May 29, 2001 01:10 PM|
|Zagi Thrust Line and cg?||NewbieX||Foamies (Kits)||1||May 04, 2001 01:04 AM|