|Dec 06, 2013, 12:17 AM|
Joined Jul 2011
DJI released the DT7 and DR16 RC system
The best choice for an entry level remote control. Simple, practical and equipped with spring centered sticks that centers when released, putting your aircraft into hover automatically.
It needs just 4 AA batteries and works perfectly with DJI flight control systems requiring only a single D-Bus cable, and provides two switches and a gimbal pitch control slider. Combined with a Naza-M flight control system, Flame Wheel series flight platform and an H3-2D gimbal, it creates the best total solution for hobbyists.
DT7 Remote Controller
5 proportional channels (including Slide Lever) and 2 3-Positon switch channels.
Low voltage alert.
Non-operation alert occurs if sticks in A\E\T\R channels are centeredwithout movements in 15 minutes.
Firmware is upgradable using the RC System Assistant Software.
Up to 16-channel remote controller support.
2.4GHz D-BUS System.
DT7 & DR16 RC System is compatible with following DJI flight control systems: NAZA-M Lite, NAZA-M, NAZA-M V2, WooKong-Mand A2.
For safety reasons, do not use the power battery for power supply during firmware upgrade.
Remember to reconfigure all parameters in the Assistant Software after firmware upgrade.
Click below to watch the connecting video
Please go to http://www.dji.com/product/dt7-dr16-rc-system/ for more information.
|Jan 05, 2014, 01:49 PM|
Ive have this ordered, hope to have it next week. looking forward to getting it, as its a good price for what seem to be a receiver with excellent possibilities.
lets hope DJI bring out a 14ch radio soon.
i will post back what i think when i get it..
this hobby is getting very expensive, im going to have to stop buying DJi products very soon. in for over 3k now
|Jan 15, 2014, 09:41 AM|
Got one of these last week. It's a pleasure to use and functions great with my Naza Lite and V2 multirotors. Truly plug and play and utterly simple to use, and the centre sprung throttle is so useful with Nazas.
I too wish the DR16 was available on its own, I'd get another couple! Contacted DJI Europe to see but typically no reply yet.
|Jan 26, 2014, 09:16 AM|
Joined Jan 2014
Need help with DR16
I have bought an dt7-DR16, but am struggeling with installing it. The instructionvideo says the dr16 needs to be plugged in X2 on the NAZA M. But there already is a cable in that slot... Do i have to take that one out ? what happens with the cable that was in it ?
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|For Sale||90mm EDF power system from Exceed RC 90mm F18||nerv||Aircraft - Electric - Power Systems (FS/W)||2||May 18, 2014 08:09 AM|
|For Sale||Immersion RC 5.8 Ghz Downlink System||Goodperson||FPV Equipment (FS/W)||3||Mar 15, 2014 06:09 PM|
|Sold||For Sale $350 My FMS Jap Zero Modified with Mr. RC sounds system V2||brandonmoon||Aircraft - Electric - Airplanes (FS/W)||3||Dec 25, 2013 01:46 PM|
|Discussion||Dji released the dt7 and dr16 rc system||Lantz||Multirotor Talk||0||Dec 05, 2013 10:38 AM|
|Wanted||WKM DJI - DJI Wookong Multi-Rotor System controller stabilizing||rui eduardo||Aircraft - Electric - Multirotor (FS/W)||0||Feb 28, 2012 05:05 PM|