Jim T. Graham has a thread on modifications, which is just above this one,
While you may not want to add that much more money to your Carbon-Z Cub, it might be worth looking at for some ideas.
I plan to fly mine off the water mostly, so I hope I don't have the same problem you did. While I don't have lots of extra cash to throw at a plane, I would go with what Jim said because I trust his judgement far better than mine.
In the end you would have a Carbon-Z Cub that you could also 3-D if you would choose to do so, or on the other hand, you would be flying at a bit less throttle and extend your flying time by a minute or two, is what I would guess what would happen.
Remember always leave some room in the tank( don't run the battery down to low voltage cutoff, that will shorten the life of your lipos.) Most pilots recommend at least 25% to 30% left in the pack. I have found that to be great advise.
I have to assemble my Carbon-Z Cub, which will happen this month. Also check out Jim's other modification, the Morgan Mill battery tray.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|New Product||E-Flite Carbon-Z Cub||ChuckTseeker||Scale ARF/RTF||18029||Yesterday 02:03 PM|
|Help!||Painting a super cub (Z foam)||BiddySlayer||Foamies (Kits)||4||Apr 06, 2014 08:38 AM|
|Discussion||Eflite Carbon Z Cub||shadow102||Atlanta Area RC||32||Nov 12, 2013 04:18 PM|
|New Product||E-Flite Carbon Z Cub.......||ChuckTseeker||Electric Plane Talk||0||Sep 05, 2013 06:13 AM|
|Sold||E-flite Yak 54 C-Z BNF Basic New Airframe $250 shipped $220 local pick up||rblos1123||Aircraft - Electric - Airplanes (FS/W)||2||Feb 28, 2013 05:33 AM|