|Nov 01, 2013, 08:15 AM|
Custom landing skid 450 Heli
I want to replace the landing skids on my Heliartist BO-105 450 sized fuselage. This means fabricating a complete new set and I'm hoping to get some ideas on how to best do this. See the link to see the design I'm going for. Note the hard angle towards the ends of the front struts.
I have tried using 6mm (od) aluminium tubing with a tube bender and this just tore the tube apart. Walls too thin I guess. Also I am not super happy to try the ice, sand, spring solutions unless absolutely necessary.
Instead I'm thinking of using a flat strip of some metal, bending it to shape and then gluing half round strips of Styrene on both sides. But I am concerned the flex will affect the adhesion of the styrene to the metal. Anyone tried this approach already?
What I like about the idea of using a flat strip of metal is that it should be fairly simple to shape and adjust to get the correct shape.
Any suggestions are gratefully recieved.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Wanted WTB: Landing Skids for Tarot/DJI 450||rcunit1||Aircraft - Electric - Multirotor (FS/W)||2||Aug 31, 2013 10:53 PM|
|Discussion Dji Phantom Custom Landing Skids- Whats available?||TheFlyingToaster||Multirotor Talk||5||Jun 29, 2013 10:47 AM|
|Wanted Align 450 Landing Skid Set||Sup||Aircraft - Electric - Helis (FS/W)||0||Jan 07, 2013 11:33 AM|
|Wanted WANT Heli 450 Gorilla Gear Standard Height Landing Skids||P.M.S||Aircraft - Electric - Helis (FS/W)||0||Apr 30, 2012 10:49 PM|
|Sold JCS unbreakable landing gear for 450 heli, with screws and Align skid tubes||anatoly||Aircraft - Electric - Helis (FS/W)||3||Dec 12, 2009 10:54 PM|