|Jul 05, 2002, 05:40 PM|
Bandit servo install,CG ?
Just got my bandit. This one seems to want the servo in the tail for the elevator. Did you all mount yours there or run a tube from near the wings?
Also there is no CG given, they just say fly it to determine CG!!!
I am guessing about 25% wing cord but what is a good start place for those of you flying already.
Also with the spoilerons, did you use down or up elevator when spoilerons are deployed. Instruction (what little there is) seems to imply down elevator of 4mm??
I am trying to figure a way to install the elevator servo in the tail but it is just a hole and barely any room for the servo arm.
Workmanship of kit is great, instructions might as well not be included.
Thanks for any help.
|Jul 05, 2002, 06:26 PM|
do a search for "bandit" in this forum and all your questions will be answered and more.... CG is 55mm behind leading edge
|Jul 06, 2002, 06:04 AM|
If you do a search on 'badnit' (note the spelling), I think you'll find your elevator servo questions answered.
Welcome to the club!
|Jul 06, 2002, 12:28 PM|
Sorry, I panicked when the plane arrived and I saw the small tail
hole. I had read almost all the bandit threads before buying the plane but was awhile ago and I was looking for performance/flyablity at that time.
Servo is installed. widen hole and installed with servo arm installed. threaded the rod while in place.
Tic, Thanks for the CG, That a little behind were I was thinking it would be, so you may have prevented a stall.
Question left is the up or down elevator with the spoilerons. I have seen comments for both up and down.
I currently have spoilerons set for 50% at full "throttle" with 10% down elevator, should be a survivable start point.
Was going to test glide today but too many wind gusts to trim it out. Even some of the big gas birdds were cartwheeling on landing.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Blade3D servo install ? Any Blade builders out there??||DGrant||Foamies (Kits)||0||Sep 15, 2004 04:40 PM|
|Zagi Servo install ?||brudford||Foamies (Kits)||1||Nov 09, 2002 11:25 PM|
|Bandit servo settings and control throws...||soholingo||Electric Sailplanes||5||Aug 04, 2002 09:20 AM|
|Bandit servo mounting||joe price||Electric Sailplanes||8||May 02, 2002 11:23 AM|