Originally Posted by Dialfonzo

For the prop in the field of view.
I have try 3 different resolution on the gopro and they don't give you the same result.
In 1080p on mine i don't see the prop but in 720p yes.

I am using the Gopro plastic case which does move the camera forward just a little bit.

Originally Posted by Dialfonzo

Size of your ESC in the arm..
I move the reinforcement a bit forward to give it more space.

What are you thinking for standoff.. 0.5" - 0.75" - 1"...?

I like .5"

Originally Posted by Dialfonzo

Size of your ESC in the arm..
I move the reinforcement a bit forward to give it more space.

What are you thinking for standoff.. 0.5" - 0.75" - 1"...?

I also like my FC on top so maybe you could make a little cover to go over the FC with your logo .:-)

Originally Posted by jsflyrv

I also like my FC on top so maybe you cold make a little cover to go over the FC with your logo .:-)

Well.. you can't mount the FC on top on that DJI Spyder upgrade.. how did you manage ?

Had to do it to get everything on board for FPV. Power board and FC board inside but the Rushduino OSD is on the outside. Its called a drill and four holes. Sorry had to cover the Logo on this one.

Originally Posted by Dialfonzo

Size of your ESC in the arm..
I move the reinforcement a bit forward to give it more space.

What are you thinking for standoff.. 0.5" - 0.75" - 1"...?

I like it, now let me know when the little 250 size is done and I will pay you for it so I can be the first kid on the block to have one.

Hahaha

Originally Posted by Dialfonzo

Tube like that...?

Ho man, those compatible Dji arms alternative are clearly a neeeeeed!
My original Dji arms have too much flex when giving full throttle. The quad doesn't goes straight.

Will you produce them? I'd take some.

What about a screw going in the tube arm preventing them to roll with vibes ?

KIPKOOL:
I think those clamps will hold up under vibes.
He was talking to me about putting a small screw in the clmp to keep it from moving. But that screw does mean something else will snapped when you give it a dirt nap!

Originally Posted by Kipkool

Ho man, those compatible Dji arms alternative clearly a neeeeeed!
My original Dji arms have too much flex when giving full throttle. The quad doesn't goes straight.

Will you produce them? I'd take some.

What about a screw going in the tube arm preventing them to roll with vibes ?

The problem with clamps is it's hard to align perfectly without screws.

But you're right, that brings another breaking point.

Their is a trick we used to do with the original T-REX 450.
We would wrap some clear tape around the section where the clap was going to secure the boom.
But then again, one could beable to twist the booms and add about 5° to each and keep your copter from spinning around very slowly.

So there is a couple good and bad reason and responses for having the round booms.
I just thought I would let you know it has been talk about.
I have watched one or two of these frames being designed.
I am sure I will see many more! ( I Will OWN A 800mm SPYDER designed by Dialfonzo.)

Have a good day brother!

Is that my 800?
Really I like the arms you made for the 250 and 516 size.

Originally Posted by DoctorAudio

Is that my 800?
Really I like the arms you made for the 250 and 516 size.

This is a Round boom version that has been asked.