|Jan 29, 2009, 01:52 PM|
Dual ESC Problem
Here's the setup: two 55mm edf units with outrunners, two card programmable SuperSimple 30a escs from HobbyCity (http://www.hobbycity.com/hobbycity/s...rogrammable)#), esc rx leads Y'd together into Rx, both esc battery lead sets soldered together. Pretty typical huh?
Here's the issue: if I disconnect one red wire (either one) to disable one bec, motors won't work--motor(s) just constantly beeps. Servo(s) still work, just not the motors. Plug the red wire back in and everything works fine. I've done this exact setup on my GWS A-10 without issue.
What am I missing???
|Jan 29, 2009, 04:52 PM|
based on what you have posted...I'm stumped too. UNLESS...snow ball's chance...the wire colors on the esc's are not where they are suposed to be. Get a volt meter and use that to identify the pos/neg wires. If this is actually the problem...run out and buy a lotto ticket with as many thirteens on it as you can fit!!
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Rondo 480 ESC Problem||GaryK||Electric Plane Talk||2||Nov 12, 2001 01:51 PM|
|Flash 5 and ESC Problem||steve f||Electric Plane Talk||5||Oct 08, 2001 02:37 PM|
|GWS GS400 ESC Problem?||Jim Taylor||Power Systems||24||Jun 26, 2001 03:17 PM|
|RCLine ESC problem(?) MSC-5NB||MrBungle||Electric Plane Talk||12||May 23, 2001 01:19 PM|
|HELP! LiteStick ESC problem??????||BH||Beginner Training Area (Aircraft-Electric)||4||May 10, 2001 09:41 AM|