|Feb 06, 2013, 11:42 PM|
Joined Dec 2001
Add channel to JR MAX-44
I just hacked into the JR MAX-44 four channel transmitter and added the fifth channel by connecting a switch as shown in first two pictures attached.
I knew it transmits six PPM pulses as the fifth and sixth channel servo holds the position to one extreme. I looked for some pictures of MAX-66 PCB connections on the web and by short circuiting the T15 and T13 terminals on the PCB found the fifth channel.
I was expecting the same for sixth channel on the other end of PCB for terminal T15D and T14 as shown in third picture but it did not work. I do not have oscilloscope to observe the correct signals, so if someone out there has experience or equipment to dig into this I am pretty sure to convert this to six channel radio.
Note: The same post exist in Aircraft-General > Radios > Add Channel switch, but since the thread is too old that’s why this has been reposted here!
|Thread||Thread Starter||Forum||Replies||Last Post|
|For Sale JR 6102 6 channel radio channel 54 with manual||mechengineer03||Aircraft - General - Radio Equipment (FS/W)||0||Jan 09, 2013 11:57 AM|
|Question JR MAX-44 radio repair help needed||PLMS||Radios||7||May 02, 2011 04:56 AM|
|Wanted JR grey cap Rx Channel 44 wanted.||NEW222||Aircraft - General - Radio Equipment (FS/W)||0||Jan 28, 2010 05:34 PM|
|Sold jr tx modules channel 44-15-16||kcomqg||Aircraft - General - Radio Equipment (FS/W)||4||Feb 12, 2009 04:13 PM|
|Sold Two JR R610M 6-Channel FM Micro Receivers -- $44 for both shipped||SPasierb||Aircraft - General - Radio Equipment (FS/W)||2||Jan 10, 2009 05:59 PM|