|Apr 06, 2012, 07:14 AM|
Help with Blade 400 / Futaba 9C setup please!
Has anyone done this? I have the RTF version of the Blade 400, and I have my Futaba 9C TX with Spektrum module.
I got it to bind, but I just can't figure out the settings to use to get the swashplate mixing correct. I got it working great on my MCPX, but I can't figure it out with this one..
I should note - I am using the stock RTF receiver in stock configuration. I don't have the stock TX for this bird. Maybe some of the servos plug spots need to be swapped? I have a fresh Spektrum RX I could use if I need to start over with a blank slate..
Any help would be greatly appreciated!!
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||MCPX setup with a futaba 9c + DM8 module||rhuber40||Micro Helis||10||Aug 13, 2013 05:47 AM|
|Sold||Futaba 9c with 2.4 and trainer setup||Nute||Aircraft - General - Radio Equipment (FS/W)||4||Dec 16, 2011 05:00 AM|
|Help!||Help...Futaba 9C Settings for a Blade mCX?||3D Romeo||Coaxial Helicopters||0||Nov 01, 2011 02:12 AM|
|Help!||Need help with futaba 9c V pitch setup||Gun Jam||3D Flying||0||May 30, 2010 01:21 PM|