|Oct 18, 2013, 07:07 AM|
Joined Oct 2013
Sanwa/Airctronics M8 and Graupner MX20 Teacher Mode
first of all, sorry for my bad english. I try my best to describe my problem.
I want to use the my old pistol radio system M8 to controll a camera gimbal.
I thought that it would be possible to connect the M8 with MX20 via the DSC connectors. I soldered a cable with the following pins connection:
3,5mm stereo audio jack for M8 (Pin 1 = Signal, Pin 2 = ground, Pin 3 - n.c.)
3,5mm mono audio jack for MX20 (Pin 1 = Signal, Pin 2 = ground)
Should be correct, isnīt it?!
When I switch the MX20 to teacher mode I get the message (analogous) "no valid teacher signal"
Does anybody know if it possible to connect properly the M8 and the MX20 ??
Thanks for any advise!
|Thread||Thread Starter||Forum||Replies||Last Post|
|For Sale Y6 Hexacopter, DJI Naza, GoPro 2 axis gimbal, Graupner MX20 radio||peoples||Aircraft - Electric - Multirotor (FS/W)||0||Jan 26, 2013 12:11 PM|
|For Sale sanwa m8 readio for parts or repair||superchamp78||Cars - Cars and Parts (FS/W)||1||Oct 09, 2012 03:32 PM|
|Discussion DJI Naza / Graupner MX20 / Failsafe Setup||fliegen||Multirotor Talk||0||Jun 21, 2012 04:36 PM|
|Discussion Graupner mx20 pitchcurve problem||thijmen5||Radios||4||May 10, 2012 01:26 PM|