|Sep 03, 2006, 08:46 AM|
Joined Sep 2005
Personally I find it easier to get the rear wheel aligned properly with the dual sided. The Tornado swingarm also makes it real easy to setup and swap tires.
|Sep 03, 2006, 09:24 AM|
From a performance standpoint, I haven't seen any appreciable difference in handling between single and dual arms. The single sided arms just get bent way too easily. And once they are bent, there is no way to re-align the rear wheel, other than to try to bend the arm back straight again! I have several bikes that still run single arms, and will only replace them with dual arms when the singles become beyond repair.
FWIW, I've already bent one of the heavy NF dual arms. But it is still servicable, because I have one of Allan W's axle adjusters on the other arm to re-align the rear wheel. I guess it's lucky that the swingarm got bent. With the dual arms I was expecting the layshafts to start getting torqued instead.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Source for double sided velcro tape?||Doc Data||Batteries and Chargers||18||Sep 29, 2008 07:46 PM|
|New Product||NEW Double sided swingarm for NF or TT||Squidlips||Motorcycles||18||May 25, 2006 05:33 PM|
|.01mm Double sided PCB for sale, CHEAP!||Propjob81||Aircraft - Electric - Airplanes (FS/W)||22||Sep 01, 2004 11:23 AM|
|Double-Sided PCB Alignment||grempel1||DIY Electronics||13||Jul 24, 2004 02:45 PM|
|Whats the best double sided tape to use for servos?||torque2me||Micro Helis||14||May 28, 2004 03:37 PM|