|Dec 16, 2012, 06:24 AM|
SD10G and 7 Channel Rx
I need to use this setup and was hoping some one has already figured out which channels to use for a four servo wing.
R= channel 4
E= channel 1
Who has done the dirty work for me?
I will also need the same for a 6 channel rx.
|Dec 16, 2012, 09:00 AM|
One of the beauties of the SD-10 is that you can assign any function to any channel #. Go into your System menu and go to type. Select the type of wing and tail you have. Then go to System/channel Assign and you can assign the function of what channels you want where.
If you need I have some basic programs for different types of planes that I can send you. If you need Airtronics stuff let me know. I am a dealer.
|Dec 16, 2012, 06:02 PM|
Ft. Mill SC / Charlotte NC
Joined Mar 2001
Just so ou know for the battery on the 6 channel you will either need a y or just piggy back off one of the others that has only a signal wire. The Y is the easiest to do if your wiring harness has all the wires going from the receiver to the wing
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||DSM2==(1) Orange 6 channel RX; (1) 7 channel Orange RX..all NIP||crosby||Aircraft - General - Radio Equipment (FS/W)||7||Sep 06, 2012 07:23 PM|
|Sold||Futaba R617 FS "7" channel FASST RX||crosby||Aircraft - General - Radio Equipment (FS/W)||1||Apr 03, 2012 10:00 PM|
|Off Site||New Airtronics SD10G w/7-channel RX on Ebay||old_dude||Aircraft - General - Radio Equipment (FS/W)||7||May 09, 2011 11:29 PM|
|Sold||NIB Airtronics SD10g w/10 and 8 channel rx team neck strap $445||cycle1racing||Aircraft - General - Radio Equipment (FS/W)||7||Nov 28, 2009 11:21 PM|
|Futaba FP-R127DF (NIB) 7 channel low band receiver and Tower 7 channel rx||cadconversions||Aircraft - General - Radio Equipment (FS/W)||1||Aug 18, 2004 09:14 PM|