|Jun 29, 2014, 05:26 PM|
Hotliner power setup suggestions (Smart and X-Ray)
I have two hotliners still new in the box and I'd like to get one or both flying. One is the Gerasis Smart and one is the X-Ray. Looking for suggestions as to modern power setups... I have no clue as to where to start. I don't need all out performance just something that will be FUN! Thanks to all in advance.
|Jun 30, 2014, 03:19 AM|
Kilsyth, Victoria, Australia
Joined Oct 2003
If either is just for fun and keeping it simple (and cheap) I'd go for 4S power. There are then a selection of nominal 35mm diameter motors that should fit and will drive around 12 to 13 inch diameter props. A good 80 amp switch mode ESC will allow you to fine tune or upgrade to further power if you want it.
Power in the 700-800 watts area will give you bundles of fun if you can fly competently but are not experienced with these sorts of models. I assume you are not otherwise you would not be asking.
An extra thought is to buy good quality but not necessarily super expensive servos.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|For Sale||GERASIS smart hotliner wings||multi-planes||Aircraft - Electric - Airplanes (FS/W)||3||Oct 02, 2013 03:05 PM|
|FS: X-Models X-Ray Hotliner RTF||jimmy6819||Aircraft - Electric - Airplanes (FS/W)||0||Jul 08, 2003 11:56 PM|
|Wanted: Hotliner, Bandit, Absolute, X-ray, etc||rickj202||Aircraft - Electric - Airplanes (FS/W)||7||Nov 06, 2002 11:38 PM|
|Wanted: Hotliner, Bandit, Absolute, X-ray, etc||rickj202||Aircraft - Electric - Airplanes (FS/W)||2||Aug 15, 2002 07:17 PM|
|FS X-Models X-Ray Hotliner||gavoss||Aircraft - Electric - Airplanes (FS/W)||1||Jul 17, 2002 06:17 PM|