|Apr 17, 2012, 10:05 AM|
Joined Apr 2012
power setup for skysurfer
Hi i am running a turnigy d2826/6 2200kv with a 35amp speed control and 6x6 prop and 3 cell 2200 bat. it seem that in flight wot the motor sputters the esc is somwhat warm and same with the motor it also seems under powered any suggestions thanks...
|Apr 17, 2012, 10:32 AM|
Too much prop... drop down to 5.5x4.5 or 6x4 at most...all you are doing is bogging down the motor and turning input power (25A-30A?) into heat. That motor is only good for around 150W-200W at most. What RPM are you getting?
|Apr 17, 2012, 03:08 PM|
The motor should be fine.
Are your electronics getting air flow? If not, that very well could be your problem.
I have a Easystar which is basically the same plane. I upgraded the system similar to yours. Everything was inside the fuse. The first couple times I flew it everything was very hot. Could not hold my finger on the ESC!
I cut a opening in the front of the canopy and cut an air passageway thru the back of the cockpit area and up and out thru the wing. Now everything stays cool.
As the others have said, a 6x6 prop is to much. I run a 6x4.
Here are some pics that show the openings.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||HK Skysurfer eq 9eagles Skysurfer eq robbe Skysurfer (eq robbe arcus airy)||hamburger||Electric Sailplanes||4||Mar 02, 2012 07:08 AM|
|Discussion||For sale - 3 aircraft and a high-power EDF setup||JohnAsaPrice||Charlotte Area Flyers||0||Feb 27, 2012 05:31 PM|
|Discussion||Swift 16 power setup for scale use?||jimm1962||Large Electric Helis||15||Jan 13, 2012 01:08 PM|
|Discussion||3D Power setup for new extra 260? HELP!!!||KrashTestKev||3D Flying||5||Nov 23, 2011 12:42 AM|
|Discussion||Common Sense Check - power setup for Chrysalis EHLG||TTC||Electric Sailplanes||5||Oct 10, 2011 08:52 PM|