|Jan 15, 2013, 03:29 PM|
Joined Oct 2007
Ok, I've got the drone assembled and it binds. However I cannot get the throttle active even though I proceed as their video shows. After putting throttle and aileron in their respective positions to activate throttle and then release -no throttle. All switches are in the up position as required. I am missing something but do not know what. I assume the receiver is binded when it becomes a solid red light and not blinking. Can anyone help? There is a bec link hanging from the gyro board but I assume it is not needed, just a auxillary. The Storm is a nice looking drone. Thanks again, Rodie
|Apr 04, 2014, 11:46 AM|
I had this same problem on starting the rotors.. heres what I did..
First remove the props to save you actually taking off etc.. takes 5-10 mins max but worth the hassle
Plug the Drone into the PC. switch on the transmitter then the drone as normal.
Start the Naza M lite software (I presume you have downloaded this already).. open the Tx calibration tab.
check all your sticks are moving in the direction they should be.. my throttle stick was found to be reversed.. as soon as I changed it the motors would arm and run.. safe to try if your props are off..
Hope this helps..
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Helipal Storm Drone||S2000442||Multirotor Talk||57||Apr 26, 2014 03:09 PM|
|Discussion||Test Flight Drone Storm FF||kingmicka||Switzerland||2||Sep 20, 2012 10:42 AM|
|For Sale||NIB Storm 70 & Storm 70 HW||hole digger||Aircraft - Electric - Jets (FS/W)||2||Jun 16, 2012 11:15 PM|
|For Sale||NIB Hoffman Storm 70 & Storm HW||hole digger||Aircraft - Electric - Jets (FS/W)||6||Jun 09, 2012 10:18 AM|
|Sold||New Storm 70 & Storm 70 HW||hole digger||Aircraft - Electric - Jets (FS/W)||3||Apr 06, 2012 04:10 PM|