Joined Feb 2012
CRIUS PRO with ArduCopterNG V2.7R1a by JLN on Y6: just 4 motor outputs working
got SW installed (with PPM sum on Throttle), seems to work.
On mission Planner outputs for all channels Ch1 - Ch6 give reasonable values BUT only 4 motor outputs work physically.
Checked with Scope- 2,3,5,6 give PPM signals (also ESCs work here...),
others all non- functional.
Tried to change APM_Config.h CONFIG_CHANNELS CHANNEL_CONFIG_CUSTOM no difference.
Is my board (other outputs) dead? Is there a test routine I can flash to the processor to have "some" signal on all pins so I can check with the Scope?
All help would be really appreciated.
P.s.: my huge & expensive Y6 frame needs a brain- PLEASE
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Crius LCD (Serial LCD v1.03) doesn't work with MultiWii 2.1?||xoxota||Multirotor Electronics||1||Nov 14, 2012 05:19 AM|
|Question||One ESC output on my HFpro board stopped working||Adidas4275||Hoverfly Technologies||9||May 07, 2012 09:27 PM|
|Discussion||Yaw issue with 4.0 upgrade on x8 and Y6||tahoelight||Hoverfly Technologies||11||May 04, 2012 01:37 AM|
|Help!||Help with 4 CH 2.4GHz BlitzRCWorks F5-E Swiss V2 Pro||SemperFiSC||Electric Ducted Fan Jet Talk||4||Mar 17, 2012 12:52 AM|
|Discussion||will Solo pro V2 RTF TX work on Solo PRO 328||andione1983||Micro Helis||0||Feb 05, 2012 08:12 PM|