The OP has CGs for the original four airframes. The other CGs are listed in the manuals?

I listed graphics with the CGs of the original four releases (AMX, F16, F18, F86) in the OP of the main Sky Angel thread HERE. The CGs for the other ones are listed in their respective manuals, most of which I have also posted links to in the OP of the main thread. Well, at least the ones that I have received. I will try to add the T33 manual ASAP.

Jon, I got my build thread finally going again. Guess what? Its on the T-45. Check it out.

Originally Posted by SkylineFlyer

Jon, I got my build thread finally going again. Guess what? Its on the T-45. Check it out.

Really nice studio photos over there Jon.

i cant wait to get one

Originally Posted by Bajora

Really nice studio photos over there Jon.

Thanks Jon, thanks to you! Why not come visit me over there...

Uh, I did already!

Originally Posted by SkylineFlyer

Thanks Jon, thanks to you! Why not come visit me over there...

Oh, but I meant for you to say HI in the thread.

Subscribed

Great info!

Thanks a bunch,

John Fruge
Madera, CA

Ordered my T-33 from BH on the 15th, got it as scheduled on the 22nd. The build was really easy - two hrs tops. Very satisfied with the fit and finish. Built straight stock (not looking for a 100mph plane) and looking forward to the maiden on Sunday.

Jim

I got my T-33 from Toysonics, great service! I am very impressed with the finish and detail of the model. The plane went together quickly. All of the supplied electronics seem to function normally.I made a few mods for my own peace of mind. I made some backup plates for the elevator and aileron control horns, drilled and screwed them on ( I dont trust glued on only). I also replaced the battery connector setup with deans connectors. I will use the supplied battery for my test flight so I had to set my radio timer for four minutes. I find the stock battery runs out of power quite quickly and gets hot! I have some 1300mah 11.1 30c batteries on order. All in all I think these 50mm jets are great and I will be buying the F9 Panther ( from Toysonics ) . Hope some of my Ideas help. Merry Christmas

They really need a 30-40c discharge battery. I did use 3s 20c 1000mah packs for a while and they worked better. But would still get pretty warm. But I am hooked on 4s now..... 400+ watts and 4s is my favorite!!!

Originally Posted by jamesdr

Ordered my T-33 from BH on the 15th, got it as scheduled on the 22nd. The build was really easy - two hrs tops. Very satisfied with the fit and finish. Built straight stock (not looking for a 100mph plane) and looking forward to the maiden on Sunday.

Jim

This is a very clean airframe! I am flying mine without the tip tanks until I can make them detachable and man....this thing moves!! I flew for 45 seconds with no motor at all. Just gliding.... I bet it would have flown wonderful on stock power but I have 4s on mine and it is close to 100mph minus the tip tanks. But it slows down very nicely for low and slow fly by's and landings. All in all it is a great flying plane!! Love it!

Originally Posted by gooniac33

This is a very clean airframe! I am flying mine without the tip tanks until I can make them detachable and man....this thing moves!! I flew for 45 seconds with no motor at all. Just gliding.... I bet it would have flown wonderful on stock power but I have 4s on mine and it is close to 100mph minus the tip tanks. But it slows down very nicely for low and slow fly by's and landings. All in all it is a great flying plane!! Love it!

I have read all of the previous posts but for clarification. Do you use the 4s battery with all of the stock components? Also is the cg in the manual correct for the T33 ?