|Aug 08, 2012, 03:49 AM|
Scrap or broken Elpor, Z-foam, EPO for paint testing
I want to do some paint testing so If you have some boken plane parts let me
know and I will buy them. Must be elapor, z foam or EPO (it's all really epo by different names).
Must be bare foam or with very little paint. I prefer wings at least pieces 6 in long or bigger.
Cheap of course. The kind of stuff you were going to put in the trash. PM me what you have.
|Aug 08, 2012, 04:55 PM|
United States, FL, Wellington
Joined May 2012
Trader Rating: 8
Be careful when doing your testing, I have found both glue and paint that was safe on my Elapor Funcub will melt the Z-Foam from Eflite. I am pretty sure Elapor is EPO but Z foam does not have the same coating on it, may be closer to EPS but I am not sure.
Anyway after rambling along...the paint and glue I used on my funcub did melt two different Eflite Z foams (one from paint, one from glue ) so be careful.
|Aug 11, 2012, 06:58 AM|
Joined Feb 2004
Trader Rating: 167
Swap meet today in Denton, TX. I'll bet there are a lot of potential "samples" there!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Question Straightening Elpor Foam||Philipp||Foamies (Kits)||3||Jun 04, 2012 02:37 AM|
|Discussion Type of paint to use for painting planes (foam)?||RPTheLefty||Electric Plane Talk||10||Mar 21, 2012 03:59 PM|
|Discussion The definitive paint for EPO foam||ny_hawk||The Builders Workshop||15||Oct 15, 2010 05:09 AM|
|Discussion EPO Foam, Elapor Foam and "Z" Foam||drypipe||Foamies (Scratchbuilt)||7||Feb 05, 2010 05:04 PM|
|Discussion EPO Foam, Elapor Foam and "Z" Foam||drypipe||Electric Warbirds||1||Feb 04, 2010 10:25 PM|