|Jun 07, 2012, 07:44 AM|
First, is it possible with an AR6100e receiver? I set my Aux3 to INH and assigned the Knob to Aux1. On my DX8 monitor screen, I can see Aux1 slider moving as I turn the knob (100% both ways).
I ran the plug from the Aux1 port on the receiver to Naza X1, but the NAZA Assistant software is not recognizing X1 output. I tried switching to X2 but get the same results. My goal is to manually set the Yaw and Vertical, but to able to adjust Pitch and Roll on the fly. Any help would be greatly appreciated.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|FS: Motors, batteries, speed control, radio (Please disregard my other posts)||David Hunt||Aircraft - Electric - Airplanes (FS/W)||14||Apr 19, 2003 11:06 AM|