|Mar 08, 2008, 11:52 PM|
CX->CX2 upgraded 4 in 1 problems
Alright so I upgraded my Blade CX receiver to a Blade CX2 2.4ghz 4 in 1 unit. I've been having some trouble with it and can't get my CX to fly. I'm using my DX7 by the way. Followed E-flite's programming instructions. The servos are working fine but its the motors. When I power up just a bit, the heli starts spinning VERY fast. It will NOT lift off the ground. I've tried switching the plugs around but nothing. One thing that I noticed was that the motor plug in things on the unit were bent during shipping. I had to unbend them to plug in the motors. This could be the problem.... GOD I HOPE IT ISN'T. I'VE HAD 3 4 in 1's DAMAGED DURING SHIPPING OR RIGHT ON FIRST FLIGHT ALREADY!
|Mar 09, 2008, 06:38 AM|
Joined Jan 2005
Your sure youve switched the motor plugs?
Sound like the gyro is trying to correct the spin by increasing power to the wrong motor and hence making it spin even faster.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||CX2 4 in 1 problems-please help||gfl||Coaxial Helicopters||8||Jan 28, 2007 06:32 PM|
|For Sale||E-flite CX Transmitter & 4-in-1||Digital Don||Aircraft - General - Radio Equipment (FS/W)||0||Jan 24, 2007 11:00 PM|
|Discussion||4-in-1 problems HELP!!!||Blade-Runner||Coaxial Helicopters||6||Jan 20, 2007 10:21 AM|
|Discussion||4 in 1 problems.. Ouch!||Rooster433||Coaxial Helicopters||7||Jun 26, 2006 10:25 PM|
|Discussion||Esky Lama II 4 in 1 problems- Please help||nbrcbeg||Coaxial Helicopters||7||Jun 13, 2006 07:14 AM|