



Discussion
Help identifying motor
I bought this "bell" motor at a swap meet. I'm trying to determine the aproximate KV so I have an idea of what it might be used for. The website didn't help much because the motors aren't shown from behind. Any help is appreciated.
Chris 




Do you have a tach? Put a couple of of black Sharpie patches on the bell, shine a flashlight at the edge of the bell, run it up on any voltage you wish, measure the rpm.... divide rpm by voltage and that will give you "raw Kv".




OK, I don't have a tach but I can read the frequency in HZ and voltage while turning with a drill. I found that I can get the voltage and RPM and use the formula Kv = ((RPM/ volt) / 1.41) / 0.95 if I know the RPM. My question is, how do I convert HZ to RPM. It gives pulses on 2 out of 3 cogs of the motor (6 out of 9 poles) so would it be (Freq/6)60=RPM? If so, that's very close to the spec of the drill. It does have the correct number of poles and magnets to be a 240821 motor.
Chris 


Joined Nov 2008
213 Posts

I don't think your drill test is going to tell you much. A lot of motors from the same manufactures just have a diffferent number of turns to vary the Kv so turning them with a drill would give the same Hz from each but the Kv's would be different.
Just as a reference a 2408 is 23.9mm outside of poles and 6.4mm deep. They have an 8mm dia mount. 



Quote:
Chris 




Mystery solved
Mystery solved. I took the motor in to the shop today and did 2 tests. For the first test, I ran it up to full speed, tached it, and measured the voltage. I came up with 13636rpm / 9.35V = 1458KV. For the second test, I checked the Speed of the drill, then turned the motor with it. The tached speed of the drill was 1260 RPM. The voltage on one phase was .63 at a frequency of 128 Hz. Using my former calculation of (128 Hz * 60)/6 = 1280 RPM. Very close. From the formula HERE Kv = ((1260/ .63) / 1.41) / 0.95 = 1493 KV. Both answers are reasonably close so I'm going to say it's equivalent to aTower pro 240821 .
Chris 
Thread Tools  
Similar Threads  
Category  Thread  Thread Starter  Forum  Replies  Last Post 
Question  Help identifying motor  7up  Electric Plane Talk  2  Dec 23, 2007 01:38 AM 
Please help identifying a motor  Cirip  Scratchbuilt Indoor and Micro Models  3  Nov 06, 2005 06:49 AM  
Need help identifying old Trinity Speed Gems motor????  jschick  Electric Power Cars  5  Sep 28, 2004 10:22 AM  
I need help with motor timing.  jtthebiggafigga  Electric Plane Talk  3  Jun 10, 2001 12:12 AM 