HobbyKing.com New Products Flash Sale
Reply
Thread Tools
Old Nov 11, 2014, 12:01 AM
Registered User
Joined Nov 2014
1 Posts
Discussion
magnetic interference to pixhawk on F450

Dear all,
I want to assemble the pixhawk on my Dji F450 frame.
I read the guide on http://pixhawk.org/platforms/multico...flamewheel_450, where the pixhawk is assembled between the top and bottom boards.
But I found most quadrotor is assembled with the FC board on the top of the central part, such as the FC is far from the power distribution board (PDB) and the battery. The battery is assembled under the bottom of the central part.
with my poor experience, I know the magnetometer should be far from the PDB, battery and the power lines of the BLC, such as to avoid the magnetic interference.
But I am not sure whether the electronic components on the FC board (e.g. pixhawk) are also subject to the magnetic interference from the PDB, battery and the power lines of the BLC.
could you please give me some suggestion? with that I could decide where to assemble the pixhawk on my F450 frame.
thanks a lot!
hansflying is offline Find More Posts by hansflying
Reply With Quote
Sign up now
to remove ads between posts
Reply


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Problem with Loiter Mode on Tarot T960 (Pixhawk) pekeqpeke Multirotor Talk 5 Oct 07, 2014 08:41 PM
For Sale F450 - Pixhawk, Scorpion motors ptweet FPV Equipment (FS/W) 6 Aug 27, 2014 01:58 PM
Discussion DJI F450 ARF & Pixhawk Build - Need advice Shamgar5k Multirotor Talk 21 Aug 14, 2014 12:35 AM
Question Pixhawk 3DR & DJI F450 altitude issue ddv2005 Multirotor Talk 4 May 15, 2014 03:25 AM
Discussion lawmate 1.2 500mw on 1280 interfers with rangelink RC madman pilot FPV Equipment 1 Oct 02, 2013 05:32 PM