|Feb 10, 2014, 05:05 PM|
Joined Jan 2014
BBY 29 Charger with a Jet drive
I am building a BBY 29 Charger mono with a jet drive from Mickie Beez from down under. It is the old school one with a flat pad on the bottom. Mick says not to run over 28000 RPM so I am going to use a old Hacker 10XL on 4S saddle packed with a Swordfish 120. I had to pre test fitted the jet drive it took about 2 hours to figure it out, I hate new stuff during that time.
The start is to cut and fit the jet drive to the hull and glue in.
|Feb 12, 2014, 01:48 PM|
Joined Feb 2014
Why didnt you put the hex out the transom? just the wear ring protrudes past the mating face a few mm, helping to locate the rear cone plus to seal it.
Glad you got it in one piece mate.
i am interested to see how this hull goes too.
Keep up the good work
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Build Log||Setting up a KMB scale 28mm Jet Drive with reverse||Tollytime||Dock Talk||29||Jan 18, 2014 02:14 PM|
|Sold||12 CH Red Super MiG-29 RC EDF Jet/with extra set of batteries||apilot||Aircraft - Electric - Jets (FS/W)||2||Nov 14, 2013 02:02 PM|
|Sold||graupner 2345 jet drives & steering mechanism with reverse||drh024||Boats (FS/W)||1||Nov 12, 2013 04:19 PM|
|For Sale||Plans for the micro MIG-29 are here. A place where concept jets come to life.||crispy1074||Aircraft - Electric - Jets (FS/W)||0||Nov 10, 2013 05:05 PM|
|Sold||12 CH Red Super MiG-29 RC EDF Jet/with extra set of batteries||smallville||Aircraft - Electric - Jets (FS/W)||9||Oct 06, 2013 11:23 AM|