Anyone know where I can source the tinly screws that fix the main shaft to the head on the Wasp V3 or V4 ?

Originally Posted by grezmel

Anyone know where I can source the tinly screws that fix the main shaft to the head on the Wasp V3 or V4 ?

Yikes! We could take care of you, but the Shipping from the USA to country would cost a little and maybe not worth it, unless you needed some additional parts. I suggest trying to find a watch or clock repair shop and see if they can help you with these tiny screws.
Let us know if we can help

Max
www.parkrcmodels.com

Originally Posted by grezmel

Anyone know where I can source the tinly screws that fix the main shaft to the head on the Wasp V3 or V4 ?

If its the .7 mm one, throw it away and get a piece of wire, preferably stainless like a safety pin or a paper clip. Trim a short bit. Put a little right hand bend on it. Push it thro the head and shaft and bend it on the other side. Keep the same amount of bend both sides to balance it tho. I got so fed up with the screws and believe me, this works great. You'll make like a U shape with the wire. There could be a little slack on it but it doesn't seem to affect at all.