|Aug 03, 2006, 10:50 PM|
Old Lyme, Connecticut
Joined Feb 2006
eRaptor 50 Emoli Battery Mounting - SHOW US YOURS
I'm currently running a 10s emoli setup on my eRaptor, with a 7s pack in back and a 3s pack mid-ship, underneath the motor. It's a little tail heavy, though. I'm toying with the idea of dropping the landing gear down about an inch to make room for a battery tray for a flat 7s pack. Then, I could adjust the position of the 7s pack to put the center of gravity where it belongs.
Has anyone else tried this? Is there any reason not to?
|Aug 04, 2006, 05:28 AM|
Joined Feb 2001
I use the standard control system and run an 11s setup (about the same performance as a 10s eMoli with my Neu Motors 1912/1.5Y). I have 7 cells in the tank area and 4 cells up front.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|go on show us your avatars||mudlark||Life, The Universe, and Politics||105||Dec 19, 2007 07:23 PM|
|Yippee!||Home made flying Hot Rods, show us yours||GregG||High Performance||14||Feb 26, 2004 08:04 PM|
|Champion Battery mounting ???||avdflyer||Parkflyers||3||Sep 20, 2001 01:59 PM|
|battery mounting methods?||Steph280||Electric Sailplanes||4||Sep 17, 2001 09:48 PM|
|ESC Wire Strain Relief & Battery Mounting||ToddO||Beginner Training Area (Aircraft-Electric)||10||May 23, 2001 08:20 AM|