|May 12, 2014, 10:24 AM|
So I went to a float fly last year and had a blast.. I threw together a slow stick just to get out there.
found that a no lube condom over the receiver and ESC work well. I flipped it over once and no issues even my cheapie Tower pro servos handled the dunk..
SO I bout a Neptune 60 and am starting the build. I got a great deal on an OS55 so I plan to go nitro, so no wet ESC to worry about. and most everything is inside. so I will keep that stuff mostly as is.. maybe do the condom and rubber band on the reciever just for that extra protection.
So on to my question the wing servos are exposed and REALLY low to the water. they will get wet.
the kit came with two plastic covers but my servos wont fit under them (they are a little bubble with a slot for the arm to come out.
I saw the posts on corrosionx and I am for sure going to go that way..at least. but do I need to do more??
Should I silicone the sides of the sevos where the case meets? and where the screws go through??
I also thought the only other place for water to get in would be where the main shaft comes out. how about putting a nice silicone or Buna n o-ring under the servo arm to seal that.. then corrosionx the entire thing?
thanks for the input in advance!
|May 12, 2014, 09:30 PM|
There is some on this thread that have waterproofed their servo's, off hand I don't recall what page(s) the information is on. It requires that you take the servo apart.
Now, I've been flying a Foamy float plane for at least six years now and the aileron servo's are mounted on the bottom side of the wing and are exposed to the water. So far, (knock on wood) I haven't had any problems.
I've had my A-5's for two seasons now and haven't had any problems, but i sealed (clear package tape) over both the flap servo's and the aileron servo's. So far, (again knock on wood) no problem's.
But, your mileage may vary.
|May 13, 2014, 05:38 AM|
Joined Mar 2014
All XQ POWER standard servos are waterproof,work long time under water no problem. you can tell me your needing spec,I'll find you a suitable one in our servo range.
|May 13, 2014, 10:34 AM|
I appreciate the input.
I will look at the XQPower servos. they are standard size servos running single side ailerons (dual aileron servos) on about 60" wingspan plane. so nothing crazy!
I do prefer a Metal gear servo but thats not a must
|May 15, 2014, 12:30 PM|
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||The E-Flite Carbon-Z Carbon Cub floatplane thread||Thomas B||Waterplanes||31||Oct 10, 2014 12:13 AM|
|For Sale||Unionville Norseman Floatplane Kit||themantoknow||Aircraft - Fuel - Airplanes (FS/W)||8||Mar 05, 2014 08:14 AM|
|Gallery||Lakes Aircraft Co 1913 Floatplane "Seabird"||davidterrell80||Scale Drawings and Three Views||0||Nov 02, 2013 08:29 PM|
|For Sale||DHC-2 Beaver Floatplane||cfv007||Aircraft - Fuel - Airplanes (FS/W)||0||Oct 25, 2013 09:56 AM|