|Jan 31, 2014, 11:08 AM|
Joined Sep 2013
TF B-25j ARF
I have searched the forums without any luck for this. Sorry if this is a repeated question.
I am putting together the Top Flite B-25j ARF. I am trying to figure out the nose gear steering servo and the rudders servo channel connections. I am using the Futaba R6014 receiver with the Futaba T10CAG transmitter.
Any ideas for set up welcomed.
|Jan 31, 2014, 06:25 PM|
United States, TX, Leander
Joined Sep 2003
I had the H9 not the TF. But I ran my rudders on a Y cable. The nose gear used pull pull steering and had a separate servo on a separate channel. I mixed the channel to the rudder, and slaved the knob on my transmitter to the nose gear. This enabled me to do some fine tuning on the steering. I did it this way, because I could. My radio was a Spektrum DX18.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Top Flight B-25j ARF Prop Nut||rshort||Fuel Warbirds||3||Jan 27, 2014 11:02 AM|
|Discussion||TF B-25j 3 Bladed Prop||rshort||Fuel Warbirds||1||Nov 15, 2013 04:55 AM|
|Discussion||TF B-25j Engines||rshort||Fuel Warbirds||0||Nov 11, 2013 02:09 AM|
|Sold||Nitroplanes 71” B-25J Twin Electric ARF||helifree||Aircraft - Electric - Airplanes (FS/W)||1||Oct 19, 2013 11:16 AM|
|Wanted||EMS ARF 50 cc Corsair NIB, TF Giant ARF Corsair, TF Giant p40 ARF||Fastandlow||Aircraft - Fuel - Airplanes (FS/W)||1||Nov 19, 2012 05:55 PM|