|Jan 04, 2013, 05:03 PM|
any every use 'GRBL'
its a serial stream Gcode 3 axis + spindle controler. can be used with a usb to serial cable and the code runs off a arduino nano 328 controller.
im working on my first cnc project, and im planning on using it.
any one ever use it?
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||Can I use any servo to use with my receiver?||easystarfpv4||Radios||7||Apr 27, 2012 11:44 AM|
|Discussion||Any harm in not using 80% every flight? Is the 80% rule even true?||LaurenceGough||Batteries and Chargers||22||May 07, 2008 06:54 AM|
|every try using a hard drive motor?||eswik||Flying Wings||8||Sep 02, 2004 01:27 PM|
|Anyone every use Probond?||LBM||Beginner Training Area (Aircraft-Electric)||36||Sep 06, 2003 05:13 PM|
|"Every gun that is made, every warship launched, every rocket fired...||Hammer Head||Life, The Universe, and Politics||47||Jul 13, 2003 11:00 PM|