|Jan 26, 2013, 03:12 PM|
Yet another incarnation of my Planktastic design. This time as a small 10" balsa model.
It's trimmed for right circles but the prop is reversed (I found winding in reverse awkward so I made the reverse prop in order to wind normally). Which means that it's turning with the torque as usual.
To counter the torque I increased the up elevon on the outer (left) wing. I also tilted the wing to the right which I hoped would keep it turning right as the torque winds down. Not sure if it works but I'm having good results so far.
It started out as a tractor but the side area of the prop made it highly unstable. Tried adding bigger and bigger tail fin but it didn't help much. Changing it to a pusher made it fly better.
Here's a video of a flight at tonight's session:
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Article||MicroDAN 2505-2900Kv Delta/Flying Wing Outrunner Motor Review||DismayingObservation||Power Systems||22||Apr 04, 2013 06:23 PM|
|Build Log||Bi-wing Flying wing||chester2240||Flying Wings||17||Feb 04, 2013 06:56 AM|
|Help!||As3x and flying wing airplanes||Jyester||Scratchbuilt Indoor and Micro Models||17||Jan 22, 2013 08:29 PM|
|Discussion||KF Swifty wing - need advice on powering this flying wing||bbz||Foamies (Scratchbuilt)||3||Jan 20, 2013 02:16 AM|
|Discussion||Topsoaring manta ray flying wing, help wanted||guitarcher||Flying Wings||1||Jan 16, 2013 02:42 AM|