HobbyKing.com New Products Flash Sale
Reply
Thread Tools
Old Mar 20, 2012, 03:13 PM
Registered User
Joined Dec 2011
15 Posts
Discussion
Is my itg3205 from WM+ bad?

I tried to connect itg3205 directly to STM32 board, but with no success.
The yellow wire is SCL, orange is SDA, green - GND, black - +3.3v.
In the code I have included ITG3205. In this I2C line I have connected successfully ADXL345.
SevenDays is offline Find More Posts by SevenDays
Reply With Quote
Sign up now
to remove ads between posts
Old Mar 22, 2012, 01:03 AM
Registered User
Hochiminh City
Joined Mar 2004
548 Posts
The SDA and SCL you can get it from the other end of 202 register where you connect the Vcc
caotri is offline Find More Posts by caotri
Reply With Quote
Old Apr 29, 2012, 03:05 PM
Registered User
Kalmar, Sweden
Joined Apr 2009
63 Posts
Did you get the ADXL to work in parallell with ITG3205 or as standalone?
Check the datasheet and make sure you did not cut away any gnd or power tracks to ITG3205.
markusb2 is offline Find More Posts by markusb2
Reply With Quote
Old Apr 29, 2012, 04:55 PM
Registered User
Polska, dolnośląskie, Wrocław
Joined Aug 2008
12 Posts
please also check continuity of SDA and SCL lines connecting pullups resistors....if you have just one resistor connected then you may have a problem....all depending on if you have any other pullups active in your lines

NB i like your small board but would cut it more straight :-) with dremel or something
darec is offline Find More Posts by darec
Reply With Quote
Reply


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion HK going from bad to worse mike_o HobbyKing 12 May 26, 2012 04:00 PM
Careful! Very poor and bad Service from Castle Creation - my case !! marknopfler Castle Creations 5 Mar 17, 2012 01:25 AM
Discussion my mustang 60 size by WM cannot do a quick loop mahmoodmusaddi Fuel Warbirds 42 Mar 15, 2012 09:29 AM
I just "ordered" my Christmas gift from my wife. Should I feel bad? Jeremy Z Electric Plane Talk 28 Dec 04, 2005 08:58 AM