|Sep 22, 2012, 02:53 PM|
Patching damaged sheeting - a brief tutorial
While repairing a badly damaged wing I've had several opportunities to patch holed sheeting. Here's my process.
1. Mark a simple geometric shape around the damaged area
2. Trim away the excess balsa, beveling the cut in the process
3. Using the side of a pencil lead, shade the opening onto a piece of paper
4. Take a minute to check the required grain direction for your patch
|Sep 28, 2012, 09:00 PM|
Mix some Deluxe Materials Model Lite filler with water to create a paste just a little thicker than water.
Apply some filler to a palette knife and dab it into the cracks.
Flatten it out with the palette knife.
Note that this mixture sets well and is very easy to sand, so applying a little extra is no big deal.
A couple of other products I'm using, both from Lee Valley Tools:
35K09.10 - Set of 12 Palette Knives in Case
99W73.38 - Sanding Sponge Assortment, pkg. of 10
|Sep 29, 2012, 04:51 AM|
Looks good so far. It's always nice to take a plane that most people would write off and make it look good as new... and sometimes even better. Filler and sandpaper are one heck of a combo
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Cool||A brief history of aviation||UlteriorModem||Life, The Universe, and Politics||0||Mar 30, 2012 02:25 PM|
|Wanted||My 1.2G Patch for your 900MHz Patch||timecop||FPV Equipment (FS/W)||9||Mar 03, 2012 08:23 PM|
|Discussion||Reapiring badly damaged sheeted foam wing||Twizter68||The Builders Workshop||8||Dec 05, 2007 11:02 AM|
|Discussion||how to repair damaged parts under sheeting?||jinithith2||Composites Fabrication||7||Aug 26, 2006 11:42 AM|
|14 sheets slightly damaged depron 75 shipped||Dennis Everett||Aircraft - Electric - Airplanes (FS/W)||8||Jun 23, 2004 02:50 PM|