|Apr 24, 2012, 07:38 PM|
I an getting ready to get a skywalker for fpv. question is i have a 5 channel radio and a 7 channel reciver. The skywalker requires 4 servos. Does that = one channel for each servo?
4 servos for skywalker plus 2 for pan tilt = 6 servos does 6 servos = 6 channels?
I have a spektrum dx5e and a ar7000 7 channel reciver.
Can I do pan/tilt with this set up?
|Apr 24, 2012, 09:08 PM|
USA, MO, Florissant
Joined Nov 2010
The servos will occupy 3 channels: elevator, aileron, and rudder. The two aileron servos will be connected to one channel, so they work together. A fourth channel will control the motor. With only one channel left, you only get pan or tilt, unless you get a transmitter with another channel. Or, you could skip plugging in the rudder servo; many fly without rudder anyway. You would have to program your transmitter to NOT use a stick to control that channel, so you could use it for camera control.
|Apr 25, 2012, 04:52 AM|
A five channel transmitter will only work the first five channels of any receiver, of five or more channels.
You seem to want -
Throttle - 1
Aileron - 2
Rudder - 4
Pan - 5
Tilt - 6
Which your transmitter isn't really capable of in the normal set up.
You could run Rudder and Aileron off the Aileron channel, (quite feasible), then use the Rudder channel for Pan. It would mean the Tilt would have to work off the 5th channel, a switch, which would only give you two positions.
The much better route would be to get a 7 channel transmitter, even a second hand one.
Another point is, 6 servos could be the absolute maximum, (or too much), for the BEC circuit if using the standard ESC unit. Much safer to get a separate UBEC to run all the servos.
|Apr 25, 2012, 09:04 AM|
You could eliminate the ailerons and fly with just rudder. The plane is basically a glider. Ailerons would give you more control, but are not absolutely necessary.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||Newbish Question - 3 channel vs 4 channel layout||kenzietech||Radios||7||Apr 20, 2012 01:38 PM|
|Discussion||Airtronics VG6DR question for channel 6||Crist Rigotti||DIY Electronics||0||Apr 07, 2012 02:07 PM|
|Question||JR 347 TX, 4-Servo DLG, and Channel 1 Question||marctrudeau||Hand Launch||2||Mar 01, 2005 05:52 AM|
|Servo/Channel Setup Question||mfeeley||Micro Helis||0||Apr 25, 2002 02:51 PM|