The Netherlands, EHKD
Joined Apr 2010
DJI Naza F450, motor nr.3 not speeding up at once.
Yesterday i recieved the wonderfull f450 kit and this morning I started the quickbuild.
Even for a newbee multicopter user it was fairly easy, so far..
After installing the software, firmware and programming I did a maiden.
It works fine but one thing I notice that the 3rd motor is 8/10 times about half a second slower with going from still to Idle.
Did I forgot to do something?
Programming Esc is required?
I have the DJI kit with the stock esc, props and engine.
Alex, normally calibrating the esc's is not required. However, I have done so about half the time with the OPTO escs. Also check you connections between the motor and the #3 esc. If you move the motor to an other esc, does it do the same thing? Switch motors to the esc. Try and isolate if it is the esc or the motor.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||DJI Naza - DJI F450 or XAircraft X650?||totality||Multirotor Talk||14||Jun 25, 2012 01:59 AM|
|Discussion||DJI F450 NAZA kit vs Witespy VC450 with NAZA kit||MC21||Multirotor Talk||5||May 16, 2012 02:16 PM|
|Sold||DJI Naza and F450 - BNF||flymustangs||Aircraft - Electric - Multirotor (FS/W)||4||Feb 20, 2012 11:36 PM|
|Found||Dji f450 + naza||h00t||Aircraft - Electric - Multirotor (FS/W)||1||Feb 12, 2012 09:33 AM|
|Sold||DJI F450 Flame Wheel White/Black NEW SEALED $70 Shipped Priority 2-3 Day Mail||Z06 Tony||Aircraft - Electric - Multirotor (FS/W)||6||Jan 01, 2012 02:04 PM|