|Jul 21, 2014, 03:22 PM|
United States, AZ, Gilbert
Joined May 2012
Hot foam cutter
Show me your hot foam cutter set up for cutting wings.
Please include your setup details. Thanks.
|Jul 27, 2014, 07:40 PM|
I use a Bow fabricated from PVC pipe and fittings. The end pieces are 1/2" PVC pipe and fittings, the center is 3/4" PVC Pipe (make sure the wall thickness allows the 1/2" PVC to slide inside, but not overly sloppy).
You can juggle the measurements to make any size bow you need. I glue the end sections with PVC cement, but not the center section, which allows me to change bow length at whim.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||Hot Wire Cutter||SayCheeze||DIY Electronics||9||Nov 16, 2013 07:25 AM|
|Discussion||Hot wire foam cutter||pencon||Scratchbuilt EDFs||71||Oct 27, 2013 06:23 AM|
|For Sale||Feather Cut Foam wing machine (Hot wire foam cutter)||thermalsurfer||Aircraft - General - Miscellaneous (FS/W)||0||Oct 17, 2010 07:51 PM|
|hot-wire foam cutter with Astro 110d charger?||esox||Foamies (Kits)||5||Apr 25, 2002 03:28 PM|