|Mar 31, 2012, 10:49 PM|
Wing servo ball links installed...
I decided after inadvertently breaking off one of the flimsy aileron link horns, to follow another fellow who used the same thing: Dubro #189 ball links (aileron type). These normally get used inside a fuselage to link the servo horns to "L" wires, but these are a fantastic way to get a solid aileron linkage!
These use a 4-40 screw to normally lock a control rod/wire in place; in lieu, I used 3/4" cap screws with 4-40 threads into the ball link, and then used CA to fix them. I then cut off the head o fthe cap screw about 1/8" in from the head base, and smoothed off. The ball/screws then thread into 5/32 holes I drilled right next to the locations of the old horns. I trimmed the material carefully first, then used white glue and matching paint to hide the wood, where showing. I started with pilot holes of 1/16" and took my time with my Dremmel.
CA was dripped into the holes first, then a drop or two onto the screws. These then got fed into the holes, and bite WELL! Wicked the CA that may have squeezed out with a Qtip. Voila! Ball linkages on my Ailerons!
I plan to use the stock control rods, though ANY 2-56 threaded rod will also do. The links come with nylon sockets that have 2-56 threads in them, and brass couplers which can be soldered or adhered using CA after cleaning the surface of a straight rod.
See pix below for finished results!
ImagesView all Images in thread
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||What's a good ball link remover plier?||tom_c5||Large Electric Helis||6||Mar 01, 2012 01:39 AM|
|Sold||6-(never flown) Hitec 645 MG servos with titanium ball links- $90.00 shipped!||540RCflyer||Aircraft - General - Radio Equipment (FS/W)||2||Oct 31, 2011 06:17 PM|
|Found||Ball link pliers and ball link sizing tool||billyzelsnack||Aircraft - General - Miscellaneous (FS/W)||0||Dec 01, 2006 01:49 AM|
|Rave||I need a link to a site showing spoiler instal.||sa-woody||Sailplane Talk||2||Jun 03, 2005 03:23 PM|