|
|
|
|
|
|
||
|
Joined Aug 2002
5,170 Posts
|
Quote:
(Most likely Power pack, but a forgotten adjustment to Tx & throttle setting changed.) 2a. Check Tx batteries are now of good quality and fully charged: 2b. Remove ESC and plug a servo into that channel to verify all is well or that there is in fact a problem with Tx. (If BEC was being used then you will also need a 4 cell battery pack with new or fully charged batteries to test) 99% of problems relate to ESC/BEC: Electronic Speed Control - Why BEC and LVC cause most EP RX problems if a servo operates well with fully charged Tx & Rx batteries and a servo, try another ESC and power pack. 3. If a problem with Tx is verified, then as per previous advises, contact your local distributor for your nearest service centre. Hitec Warranty & Service - homepage. Note: Hitec USA only services North/South America and Canada. "Hitec USA customer service department is available Monday through Friday* from 7am- 4:30 pm Pacific time. Reach us at 858.748.8440 or service@hitecrcd.com any time you have a question" • If you are from a country that is outside North and South America, please contact the Hitec distributor in your country for service. Alan T. Alan's Hobby, Model & RC FAQ Web Links |
|
|
||
|
|
|||
|
|
Today, I had the same problem. I didn't wait but I tightened the throttle stick with full force. Beeps were resolved. This is strange bevaviour of my stick:
It has been from I have bought this TX. When I have set a throttle range in ESC (some time ago), I have been tightened this stick with full force, too. But when I always turn on ESC this stick is on second "teeth". I had this problem before first flight (before second everything was OK) and it was quite cold outdoor. Is this normal? Is my potentiometer broken? |
||
|
|||
|
| Thread Tools | |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wanted Dx6i B5K potentiometer or DX6i for parts | pavcon | Aircraft - General - Radio Equipment (FS/W) | 9 | Jul 09, 2012 05:46 PM |
| Discussion How can I modify a brushless esc to be controlled with a potentiometer? | Steve Klyce | Power Systems | 5 | Apr 15, 2008 06:19 PM |
| Astro 110D with bad potentiometer | JoeR | Power Systems | 18 | May 29, 2002 03:49 PM |