|Feb 02, 2012, 09:09 AM|
santa barbara, CA
Joined May 2009
shorten pentium motor wires?
don , i am having a space issue w/ the wicked wemo combo in my j power mini f9f . is it ok to shorten the output wires on the esc (pentium 30) . i wont shorten the motor wires per your instructions.
|Feb 04, 2012, 03:58 PM|
The motor wires are just extensions of the winding wires inside the motor. So if you shorten them them you no longer have nice soldered tinned ends. You will have many strands of insulated/enamel coated wire which you cannot solder to. You would need to then strip the enamel off of each of the three motor wires, but each motor wire is made up of about 10-12 smaller substrands of thinner wire so you would have to strip ~30-36 wires and then retin them for soldering. I have done it once to see if I could do it and it is very easy to break the smaller strands off or not get them stripped off properly so instead of all 12 wires carrying the amp load in one phase, say only 8 carry the load so a phase can burn out.
|Aug 18, 2013, 01:28 AM|
Thanks for the heads up
Thanks for the explanation Don.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||Is it O.K. to shorten the Lipo wires?||papabearflying||Electric Plane Talk||7||Aug 15, 2011 12:34 PM|
|Discussion||I actually need to SHORTEN my ESC wires||Staggerflyer||Castle Creations||2||Apr 25, 2011 05:55 PM|
|Discussion||Shorten motor wires||Petefoss||Castle Creations||1||Jan 12, 2007 06:11 PM|
|Discussion||Can I shorten Kontroniks ESC battery, motor, or receiver wires?||kenmalecki||Electric Heli Talk||2||Jun 11, 2006 09:18 PM|
|Discussion||Shorten the wires to the motor?||Old Fart||Castle Creations||2||Apr 17, 2006 01:50 PM|