|Sep 20, 2011, 10:34 AM|
ESC Question ** Magister **
I inherited a new garage sale Multiplex Magister. I has a new 680 brushed motor installed. I would like to use my Lipo battery in this plane, but it appears that the ESC and Motor are looking for a different voltage. Installing a modern ESC (3 wire) wont work with this (2 wire) brushed 680 motor. ? correct?
I suspect that I need to follow the recommended complete upgread to an AXI motor/ESC/Lipo. I'm assuming that this modern setup will work with the HiTech receiver that's in the plane.
Thanks in advance.
|Sep 20, 2011, 10:48 AM|
Brushed motors cannot be used with brushless ESCs, and vice versa. They operate on fundamentally different principles.
Rather than buying an obsolete ESC for a brushed motor, I'd be tempted to rip out the entire drive system and to go completely brushless. It could probably be done for $40 or less if you're into budget componentry, but it wouldn't be an AXI (premium) motor. More like Hobbyking or RCTimer.
The "modern" (brushless) ESC will work with the older Hitec receiver, but a bigger question is whether the receiver will work with your transmitter - or did you get one of those with the plane as well?
|Sep 20, 2011, 04:49 PM|
I have the transmitter. A 72m mhz machine. I'll have to power it all up and see if it works. I scrounged up a brushless motor. I'll swap out the entire power package.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||Exceed-rc ESC and AEO RC EDF question||The6uest||HobbyPartz.com||2||Sep 15, 2011 09:54 PM|
|Question||HK F-14 fan,motor,esc question. Plus a GREAT buddy code for motors posted||MiG-3 Reno Rocket||Electric Ducted Fan Jet Talk||6||Sep 10, 2011 12:25 PM|
|Discussion||ESC question||nickwad||Power Systems||1||Sep 05, 2011 02:02 PM|
|Discussion||ESC wire twist question||milo12||Power Systems||1||Sep 04, 2011 05:52 AM|
|For Sale||multiplexe magister frame only ie wings fus,125 eastof the miss. 135 west, shipped||kgn831aa||Aircraft - Electric - Airplanes (FS/W)||1||Mar 17, 2011 12:59 AM|