|Dec 05, 2013, 12:08 AM|
Joined Dec 2013
Spektrum DX7 Tx Help needed for Blade MCX 2
Just purchased an mCX 2 BNF heli to learn to fly with. I also have a Spectrum DX7 transmitter to fly it with. My question is how to best set up the radio to fly the heli with? Any help would be greatly appreciated.
|Dec 05, 2013, 01:30 AM|
It's really simple... just bind the helicopter to a new airplane model (don't use heli for easiest setup). You don't have to do any settings, just bind the heli to a 'blank' airplane model memory and you're good to go! If you want to use expo or something, you can do that, but the mCX is really easy to fly. If you have the old DX7 you might need to reverse some channels but that should be immediately apparent when you lift off.
In case you don't know... all controls work as if you're the pilot sitting in the cockpit. So, for rudder, make sure you set it up so when you push left the NOSE goes left, not the tail. Then you'll be learning properly for more advanced helicopters.
Good luck, it's a ton of fun!
|Thread||Thread Starter||Forum||Replies||Last Post|
|For Sale Spektrum DX7 Tx||smking0656||Aircraft - General - Radio Equipment (FS/W)||0||Dec 03, 2013 07:17 PM|
|Trade Blade MCX for trade||nightcrawler17||Want To Trade||0||Dec 02, 2013 07:28 AM|
|For Sale Spektrum DX7 and Chainlink TX/RX||manolinpinguin||FPV/RPV - Equipment and Vehicles (FS/W)||3||Nov 20, 2013 03:16 AM|
|Wanted Your msrx rotor blade set and mcx2 flybar for 2 mcx rotor sets and 2 mcx swashplates||RcAirplaneNoob||Aircraft - Electric - Helis (FS/W)||0||Oct 31, 2013 02:29 PM|
|Discussion Blade 350QX - Spektrum DX7S config - Pls Help||rctoyguy||Multirotor Talk||7||Oct 18, 2013 09:32 PM|