|Aug 01, 2011, 08:04 AM|
Joined Dec 2002
Signal wire needed on CC BEC ?
I have run out of channels in my CCPM 450 clone and would like to use a Castle BEC. The Gyro gain plug has only a signal wire so I am wondering if I can pull the red and black pins from the castle plug and put them into this one. Is there any reason the signal wire needs to go to the receiver? I will make an adapter to use if I ever need to use the PC. I prefer using an adapter only while not flying rather than a Y connector in-flight.
|Aug 01, 2011, 10:15 PM|
Overland Park, Kansas, United States
Joined May 2003
The signal wire is not required for in flight use on the CC BEC. It is there for Castle Link purposes only.
Your solution sounds very neat and tidy, but most would just put a small Y adapter in there....
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Connection Advice on CC BEC||natss||Batteries and Chargers||1||Jul 20, 2011 01:40 PM|
|Discussion||Which wires on ESC going to motor are positive/negative and signal wire?||cannondale1974||Power Systems||11||May 15, 2011 09:57 AM|
|Wanted||CC BEC Pro or CC BEC needed||lmopar69||Aircraft - Electric - Power Systems (FS/W)||1||Mar 20, 2011 01:10 AM|
|Discussion||Is the built in 5A BEC on CC ICE 100 as powerful as the CC BEC on 6s?||cleansho93||Electric Ducted Fan Jet Talk||12||Mar 15, 2011 03:53 PM|
|Discussion||Is the built in 5A BEC on CC ICE 100 as powerful as the CC BEC on 6s?||cleansho93||Foamy EDFs||0||Mar 15, 2011 12:29 AM|