Joined Mar 2016
Spreading Wings 900 LED Indicator only flashes read
I am trying to figure out what is wrong with my Spreading Wings 900 with an A2 flight controller. Here are the signs and symptoms:
Startup light sequence incorrect - only flashes red.
LED indicator light doesn't change with mode changes.
Won't go into compass calibration mode.
Here is what I know.
IMU calibration is good.
TX is linked to the receiver with good link indication light
All components are upgraded with the latest firmware.
Mode switched is mapped properly. (GPS Atti, Atti, & ATTi or Manual are highlighted blue with mode changes)
I haven't seen any color other than red on the LED. It's not continuous, it flashes. As I type it's flashing twice, which is probably indicating the number of satellites in view (I am inside).
Been searching for solutions for days.
I am hopeful you guys can help me identify the problem.
Thanks so much,
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||Indicator Light (LED) To Show Power On||JD-Slow-Thumbs||Power Systems||6||Sep 29, 2015 02:26 AM|
|Discussion||Problem flashing turnigy 9x on mac osx? read this.||akcom||Multirotor Electronics||0||Jul 03, 2014 11:33 PM|
|Question||Flashing LED on vTX||Hajile||FPV Equipment||1||Dec 14, 2013 09:28 AM|
|Help!||Seagull problem: Constantly on indicator LED||emreyk||Eagle Tree Systems||3||Apr 02, 2008 02:00 PM|
|Question||LED "ON" indicator in my DX7||flybyday||DIY Electronics||4||Dec 05, 2007 04:31 AM|