|Jun 01, 2006, 10:09 AM|
Melbourne, Eastern Sub.
Joined Sep 2004
Spinner on Outrunner Suggestions
Please help !!
My balsa P40 is just about complete, however, attaching the spinner to the outrunner is proving a bit tricky.
I would like to know how other people have done this, or if there are any good products on the market that can simplify the process.
I am using a GWS adapter with a GWS 9x47, with a DuBro 1.75" spinner (see setup photo). The main trouble is the DuBro backplate hole is too big for the GWS adapter. I have search the forums for ideas and all I've found is the following.
It could possibly be solved by gluing a thin ply plate to the front of the backplate and then drill the correct size hole to accomodate the GWS adapter. However the thread on the GWS adapter is very small, I even had to cut some plastic off the prop just to be able to bolt it on. So if I use the thin ply I'm really going to cut it short with the thread.
Can anyone suggest how this could be done? If I was to use a collet type adapter I would need a thead on it about 20-25mm long.
Are ther any other adapters out there that will do this?
|Jun 01, 2006, 10:56 AM|
I think you need an MPJet "long" collet adapter in the appropriate diameter. In the US, you can get them from Hobby Lobby. The outer diameter of the shaft will be very close to the size of one of the spinner inserts, you might need to ream it a little. Also, consider using an APC prop instead--they can handle more power than the GWS props and include the correct inserts to fit the MPJet adapter shaft.
|Jun 01, 2006, 11:30 PM|
Here is the page you need.
Looks like your motor shaft is probably 4mm, maybe smaller. Just pick out the long adapter in the correct size for your shaft. Then use an APC prop or drill out the middle of your GWS prop to fit.
|Jun 02, 2006, 12:08 AM|
Joined Nov 2004
We carry prop adaptors from 2 mm to 6 mm.
Check this website: http://www.euromodels.com.au/shop/in...dex&cPath=4_42
|Jun 02, 2006, 12:16 AM|
As I se it , your problem is trying to use the GWS prop.
As all have suggested, loose the GWS adapter and get the proper collet adapter, and then, using the inserts supplied for the backing plate of the spinner, you will have no problem mounting it.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Mounting Glow Spinner on Outrunner||fly4fun||Electric Plane Talk||2||Jul 25, 2007 02:44 PM|
|Help!||2.75" Spinner on a 4mm Shaft - need suggestions||tommy321||Scale Kit/Scratch Built||2||Jan 23, 2007 02:10 PM|
|Discussion||How can I mount a propeller and spinner on an outrunner?||Dave K||Power Systems||3||Dec 06, 2006 08:57 PM|
|Discussion||Formosa spinner on Outrunner||GPT||Parkflyers||4||Jan 26, 2006 05:35 PM|
|Spinner on a Mini Laser 3D||Michael in Toronto||Sport Planes||1||Jul 12, 2001 01:34 AM|