|Dec 17, 2013, 06:45 PM|
United States, TN, Lenoir City
Joined Oct 2012
Most Cost Carbon Fiber Parts
I'm just about done with my frame design for my Quadcopter and I want to make it out of 3mm thick carbon fiber. All parts are flat and should only need to be cut out and then motor mount holes drilled into it.
I have spoken with RealCarbon and will be getting a quote too, but I just want to know where the most cost friendly place to get this done is!
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Custom carbon fiber parts||CornelP||Racing Boats - Electric||2||Nov 28, 2013 11:39 PM|
|Discussion||Need a carbon fiber part cut||AnthonysQuad||Multirotor Talk||8||Nov 20, 2013 01:55 PM|
|Sold||13 Outrunners, Most NIB, $150 (Cost me over $500)||MCSGUY||Aircraft - Electric - Power Systems (FS/W)||4||Nov 18, 2013 05:38 AM|
|Discussion||Fast food chains costing taxpayers the most money.||dll932||Life, The Universe, and Politics||72||Oct 24, 2013 07:44 AM|
|Low cost carbon fiber rods||RobertV||Parkflyers||1||Oct 26, 2005 07:33 PM|