how to mount this motor on to my funjet motor mount????
anyone post a picture?
do i need to open my motor up?

motor: HXT 2835 (380S) 2700kv Brushless Inrunner
http://www.hobbyking.com/hobbyking/s...idProduct=4201

That motor should just bolt right on, no modification necessary.

Originally Posted by Mattvr1ck

That motor should just bolt right on, no modification necessary.

with M3 screw? do i need screw nut to make it stable?

No, the motor comes with bolts that bolt through the motor mount on the funjet and into the motor. Couldn't be easier!

shoot, i didn't see the bolt....

and there is no bolt ....

Originally Posted by bobmaxiao

with M3 screw? do i need screw nut to make it stable?

Yes, with an M3 screws. Don't try to take your motor apart. Take the rear plate off the tail piece and screw the motor to it with short M3 screws.

Originally Posted by radialarm

Yes, with an M3 screws. Don't try to take your motor apart. Take the rear plate off the tail piece and screw the motor to it with short M3 screws.

but are the screws coming along with the motor? or i've to get them myself?

Comes with the motor

but i don't have any bolt with the motor.. how come.

Sometimes you don't get screws. You will need 2 M3 x 7 or 8mm screws. I don't know how easy they would be to find in Singapore. Maybe an electronics shop. I used button head with a socket. As I recall they needed to be flat as possable to clear the prop adapter. Regular socket heads were too tall and needed a washer to keep from pulling through.

Originally Posted by radialarm

Sometimes you don't get screws. You will need 2 M3 x 7 or 8mm screws. I don't know how easy they would be to find in Singapore. Maybe an electronics shop. I used button head with a socket. As I recall they needed to be flat as possable to clear the prop adapter. Regular socket heads were too tall and needed a washer to keep from pulling through.

oh, really thanks a lot. I'll go get it.