HobbyKing.com New Products Flash Sale
Thread Tools
Old Jun 13, 2012, 06:10 PM
Registered User
Joined Jun 2012
1 Posts
Turnigy Centurion Mini Brushless Catamaran ESC Programming help

Nice little boat but cannot find programming info on esc. It's a 30amp esc red in color. No identifying marks on it and the menus are not the same as the turnigy esc's programming but they seem to be very close. Once in programming the beep sequence is as follows.

1 short - 1 short, 2 short, 3 short - not sure
2 short - 1 short, 2 short, 3 short - not sure
3 short - 1 short, 2 short, 3 short - not sure
4 short - 1 short, 2 short - Lipo/Nimh?
1 long - 1 short, 2 short, 3 short - not sure
1 long 1 short - 1 short, 2 short, 3 short, 4 short, 1 long, 1 long 1 short - Timing?
1 long 2 short - 1 short, 2 short, 3 short - not sure
1 long 3 short - 1 short, 2 short - Reset to defaults?
3 long - end point

Any ideas what they might indicate? HK doesnt have a manual on the esc...
ibblind is offline Find More Posts by ibblind
Reply With Quote
Sign up now
to remove ads between posts
Old Sep 03, 2012, 07:35 AM
Registered User
Joined Sep 2012
6 Posts
mine came pre programmed out the box?
gavin3171 is offline Find More Posts by gavin3171
Reply With Quote
Old Sep 04, 2012, 12:37 AM
Micro Boat Forum Founder
boredom.is.me's Avatar
United States, GA, Buford
Joined Nov 2007
6,526 Posts
At least a picture please.
boredom.is.me is offline Find More Posts by boredom.is.me
RCG Plus Member
Latest blog entry: RFD900 Case
Reply With Quote
Old Aug 09, 2014, 09:26 AM
Registered User
Joined Oct 2013
40 Posts
I have tried to figure out how to programm the esc either.. I have gone through all available hk speed controllers for boat and couldn't find the pattern I heat after entering the programming mode.
What brougt my attentions was how the "not named" esc looked. It looks like a normal esc re-built for boat usage - I suppose it must be something from the hk esc range - after looking at many speed controllers it seems that it could be something similiart to http://hobbyking.com/hobbyking/store...ontroller.html Blueseries 30A. In the manual http://www.hobbyking.com/hobbyking/s...28X70599X0.pdf the sequence is almost identical.. I have not tried it yet, though..

hexbub is offline Find More Posts by hexbub
Reply With Quote
Old Aug 16, 2014, 11:27 AM
Boaters are nice people.
Sneek, Netherlands.
Joined May 2004
5,136 Posts

I'm using these instructions to program my no name/rebranded ESC's:

Regards, Jan.
pompebled is online now Find More Posts by pompebled
Reply With Quote
Old Dec 20, 2014, 12:00 PM
Registered User
Joined Sep 2014
23 Posts
do you know how much mm is the axle when the rudder is held to?i'm thinking of putting this rudder on my joysway smx
spiros is offline Find More Posts by spiros
Reply With Quote

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion can I use my turnigy esc programing card with me rctimer esc? imdone Multirotor Talk 4 Jun 08, 2014 06:14 PM
Question Help with ESC selection and ESC programming Power_user_EX Power Systems 0 May 18, 2012 05:09 AM
Discussion HK Centurion catamaran Shaft!! El cata Racing Boats - Electric 1 May 03, 2012 12:39 PM
Discussion Turnigy programing card.to 120a esc marine Bernhard BB Racing Boats - Electric 13 Oct 20, 2011 09:43 AM
Sold mini catamaran - brushless Vasy Boats (FS/W) 0 Dec 06, 2009 12:02 AM