|Jul 14, 2012, 05:48 PM|
The vee is ready to go.
- FG hull
- 140mm long, 156mm with all hardware
- 40mm wide
- adjustable trim tabs
- fully adjustable stinger drive
- NO FLEX SHAFT DRAMA!
- interchangeable rudder mounts for aesthetics or offset
- pure beastliness
No more till later.
The only down side is the high part count. Without the trim tab associated parts, there are 24 parts. With the tabs, 28.
|Jul 18, 2012, 12:39 AM|
140 by 40mm? sounds like an open ocean racer, a far cry from a crackerbox
so going long and narrow instead of short and maneuverable?
interested to see what comes from it
|Jul 18, 2012, 01:49 AM|
Ya I'm going for a more reliable, less playful type thing. You know, trying to get a little more serious on straights.
I was looking at the mSRX main motor for power. It is an 8.4mm with an even longer can! I want to try out my custom props too. Everything about this would be purposed for it. I want to use an Rx31 within a custom housing to make it waterproof. I may need an esc as I'm scared that the standard 2 amp would blow especially since it is built in. Also an hk5320 servo which shouldn't have to worry about water too.
The hardest part is getting the plug made. What's funny is that that was the easy part for the cat, and the hard part was everything else. It's backwards now.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Build Log||26" 1/18th scale scratch built Downeast(lobster) boat||CMEboston||Scale Boats||30||Nov 21, 2010 07:59 AM|
|Sold||Miss vegas hydro boat 100% rtr!!1 used,,runs strong!!!||Silverdragon||Boats (FS/W)||1||Aug 01, 2010 04:38 PM|
|Off Site||FS 1/8 Scale B28 BAT BOAT Hull & Hardware only||K.R.Joye||Boats (FS/W)||0||Nov 23, 2009 09:05 AM|
|Discussion||1/30 scale Empire Flying Boat - is Depron waterproof enough||RJPIoW||Waterplanes||9||Sep 23, 2009 12:01 AM|
|Discussion||orco2 is "iom" boat or 1 meter boat ?||vasp||Sailboats||4||Mar 19, 2008 03:08 AM|