HobbyKing.com New Products Flash Sale
Reply
Thread Tools
Old Sep 06, 2014, 07:47 PM
Registered User
rrothman's Avatar
Joined Nov 2011
29 Posts
Quote:
Originally Posted by AA5BY View Post
A flying friend got one of the OS gas four stroke engines. He had starting problems beginning about the 3rd outing. They got worse but if once getting it running, it ran fine. It finally got to the point that it was very difficult to get the engine started. After trying everything imaginable with the fuel system, he tried an RcXel ignition and the beast now starts easily.

It was my first time to see a gas engine with ignition problems that made starting difficult but then run fine. Usually it is the other way around, an engine will start easily but not spool up or will miss at higher rpm when an ignition is balky.
Did he get an ignition from rcexl or rcxel? where did he get it, I can't find rcxel and the rcexl.com website is terrible to figure out and haven't seen any way to purchase anything directly anyway, but I saw this http://www.rcexl.com/notice/5.html which made me look up ch-ignitions.com on which I don't see anything about rcxel but I like what they're selling!
rrothman is online now Find More Posts by rrothman
Reply With Quote
Sign up now
to remove ads between posts
Old Sep 06, 2014, 10:06 PM
Registered User
AA5BY's Avatar
East Texas
Joined Aug 2007
1,061 Posts
Quote:
Originally Posted by rrothman View Post
Did he get an ignition from rcexl or rcxel? where did he get it, I can't find rcxel and the rcexl.com website is terrible to figure out and haven't seen any way to purchase anything directly anyway, but I saw this http://www.rcexl.com/notice/5.html which made me look up ch-ignitions.com on which I don't see anything about rcxel but I like what they're selling!
He actually borrowed an ignition from DLE-20 that was not in use.

If looking for RCexl ignitions, (not RCxel - my typo bad) I've been getting them from Agape Racing and Hobby.

http://www.agaperacingandhobby.com/
AA5BY is online now Find More Posts by AA5BY
RCG Plus Member
Latest blog entry: Big Red
Reply With Quote
Old Sep 07, 2014, 06:11 AM
Registered User
Tucson
Joined Nov 2009
980 Posts
Gas normally flows out of the carb, back to the tank, when the engine is not running. As long as your air intake is open (or you have a pin hole in it, as many do) your carb is not quite airtight.

The real problem is if you get air bubbles coming from the tank to the carb.

If you choke the carb and turn the prop, then it should pump fuel from the tank. If it doesn't, then there is a problem. My opinion.
wuest3141 is offline Find More Posts by wuest3141
Reply With Quote
Old Sep 07, 2014, 10:47 AM
Registered User
rrothman's Avatar
Joined Nov 2011
29 Posts
Quote:
Originally Posted by wuest3141 View Post
Gas normally flows out of the carb, back to the tank, when the engine is not running. As long as your air intake is open (or you have a pin hole in it, as many do) your carb is not quite airtight.
While it seemed like gas was flowing back due to a leak, it was I believe the ethanol expanding and boiling due to the heat build up from being idle next to a hot engine.
Since switching to TrueFuel (ethanol free) and the original pumper diaphragm, I have not had the same problem.

Quote:
Originally Posted by wuest3141 View Post
The real problem is if you get air bubbles coming from the tank to the carb.
Actually I put in a RotoFlow tank that it supposed to be air bubble free, while I still get bubbles in the fuel line, they are not severe enough to stall the engine - not even a minor hesitation.
rrothman is online now Find More Posts by rrothman
Reply With Quote
Old Sep 15, 2014, 10:16 AM
Registered User
rrothman's Avatar
Joined Nov 2011
29 Posts
well I finally had the chance to go fly it this weekend, while it ran well on the ground idle at 1900 and WOT was around 6900 rpm, something didn't sound quite right in the air. brought it down and without killing the engine, secured it and ran up the throttle again, but it sounded fine as usual. so took off again and started doing rolls when the engine stalled! barely got it back to the field where I pancaked it in the rough grass, ripping the landing gear off which put a hole in the wings and dislodged the engine/firewall from the bulkhead. been too busy so haven't pulled it apart yet for full autopsy but I strongly suspect air bubbles from the "air bubbless RotoFlow" did it in, but am thinking I may switch to electric with a Hacker Motor.
rrothman is online now Find More Posts by rrothman
Last edited by rrothman; Sep 15, 2014 at 08:14 PM.
Reply With Quote
Reply


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
For Sale Nice! Bisson Custom Muffler For Evolution 45GX & 50GX rcidaho Aircraft - Fuel - Engines and Accessories (FS/W) 0 Jan 28, 2014 05:52 PM
Sold Evolution 50GX binujoe Aircraft - Fuel - Engines and Accessories (FS/W) 1 Nov 07, 2011 09:51 PM
Sold Evolution 50GX Gasoline 50-cc Engine / Muffler Dynomike Aircraft - Fuel - Engines and Accessories (FS/W) 3 Oct 18, 2009 08:47 PM
Discussion Evolution 50gx jschauer Giant Scale Airplanes 0 Jun 14, 2009 09:31 AM
Discussion Evolution 50gx jschauer Engines 0 Jun 08, 2009 06:35 PM