|Dec 19, 2013, 06:34 AM|
Joined Jun 2010
EagleTree guardian 2d/3d Problem
i just received my new EagleTree guardian 2d/3d Problem for my aeroworks extra 300 QB .60 .90 i set it up inside my model yesterday and all seems to work fine, after i reseted my flight levels and trim as per the manual and it did reset and gave me the indication, i kept it the plane power & Tx power on and turned my head into the maual for 2 min and heard some servo movements i looked bad and my ailerons we out of position banking the plane to the right !! i moved the stick on my Tx and all centered again ? then i observed and saw that the ailerons move a notch banking to the right every 4 to 5 seconds without me commanding so...?
i turned off the heading hold in 2d mod and it stopped doing so ?
in 3D mod it does the same but added the rudder moving to the left with the aileron a notch each every 3 or 4 seconds more gain i add it shorten the time between notches!!!!
Any one knows why is this happening and if there is a solution for that please ??
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||Guardian 2D/3D servo jitter problem||SebbeMalm||Eagle Tree Systems||12||Jun 10, 2014 06:29 AM|
|Discussion||Guardian 2D/3D Rudder Problem||wedgewalker||Eagle Tree Systems||4||Apr 05, 2013 03:05 PM|
|Discussion||Problems with 2D/3D Guardian.||Menestrel||Eagle Tree Systems||1||Dec 11, 2012 10:27 PM|
|Discussion||Guardian 2d/3d problem||dgavalis||Eagle Tree Systems||1||Jul 06, 2012 08:37 PM|